For a British American type lamp to pass, you must also make sure the brightest part of the image moves downwards when the lamp is dipped. If you fail to plan it can sting you with motoring. Legally you csnt drive the car with bald tyres and could land you 6 points and a big fine for driving like that. I'd argue what harm could driving a mile home at 20mph through local traffic do. But the law is pretty clear on the matter.

Towbar mounting points are not prescribed areas and the vehicle structure should only be rejected if its strength or continuity is significantly reduced. You should only reject door hinges, catches and pillars for deterioration if it causes the doors not to work as intended. Defect Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Switch on the rear fog lamps and operate all the other lamps in turn to see if the rear fog lamps are adversely affected. The following must have a pair of main beam headlamps and a pair of dipped beam headlamps – can be separate or a single pair of headlamps: Vehicles first used before 1 September 1965 may have white front indicators and red rear indicators, if the direction indicators are combined with stop lamps or combined with front or rear position lamps. Tricycles and quadricycles classed as mopeds do not need hazard warning lamps. Only ‘bodied’ mopeds must have direction indicators. Defect Not tested” or “Unable to be tested” must only be used where it becomes apparent during the test that the particular item cannot be tested, and this could not have been identified prior to starting the test. The reason for selecting the failure must be included in the additional information box. Defect

Autumn Statement: Workers to pay less in national insurance – but rate cuts don't offset the freezing of personal tax thresholds

an asymmetric dipped beam pattern with a flat-topped area of high intensity extending above and parallel with the horizontal 0% line on the nearside